|
Custom Color Insert
Series Assembly Instructions
|
|
Standard and Sound Models:
Peel protective cover off foam tape on the back of front panel at
top and bottom. Place one side of panel behind channel. Flex panel and
push or snap behind channel on other side. Press in at center of panel to
secure tape.
|
 |
 |
Install the back panel by placing one side behind a channel and flexing
behind the channel on the opposite side. NOTE: The four holes in the
panel align with the four screws on the back.
Install shelves over screws and push down to lock in place. NOTE: If you
are installing a sound system, do not install bottom shelf.
|
Installing the Audio System
(Sound
Models Only) |
|
Install the speaker wire to the back of the speaker. Pass the wire through
the unit so that it extends out the back. Secure the speaker with four
black push in clips. Install the four large black grommets in the front
panel. Install the speaker cover into the grommets.
|
 |
 |
Install the amplifier mounting bracket. Install the amplifier following
the instructions with that unit. NOTE: Discard the black plastic speaker
back cover. It is not used in the application
|
 |
|
|
|
|
|
05/05/2008 02:34 PM |
|
|
|
