|
Custom Radiused Lectern Assembly Instructions
|
|
Standard and Sound Models:
Peel protective cover off foam tape on the back of front panel at
top, bottom and center. Place one side of panel behind channel. Flex panel
and push or snap behind channel on other side. Press in at center of panel
to secure tape.
NOTE: This panel may be difficult to install without assistance.
|
 |
 |
Install the back panel by placing one side behind a channel and flexing
behind the channel on the opposite side.
NOTE: The four holes in the panel align with the four screws on the
back.
Install shelves over screws and push down to lock in place.
NOTE: If you are installing a sound system, do not install bottom
shelf.
|
Installing the Audio System
(Sound
Models Only) |
|
Install the bezel with two black push in clips. Install the speaker wire
to the back of the speaker. Pass the wire through the unit so that it
extends out the back. Secure the speaker with four black push in clips.
Install the four large black grommets in the bezel. Install the speaker
cover into the grommets.
|
 |
Remove one set of screws and install the amplifier mounting bracket.
Install the amplifier following the instructions with that unit.
NOTE: Discard the black plastic speaker back cover. It is not used in
this application
|
 |
|
|
|
|
|
04/14/2008 10:30 AM |
